- Posts: 44
- Thank you received: 0
Creep Range
- sabir
- Topic Author
- Offline
- Senior Member
Less More
16 years 7 months ago - 16 years 7 months ago #7185 by sabir
Creep Range was created by sabir
What is called "Creep Range" with reference to Flanges...??
and in MSS SP - 44, what is this SP stands for. Is it Standard Practice...
Regards,
Sabir
and in MSS SP - 44, what is this SP stands for. Is it Standard Practice...
Regards,
Sabir
Please Log in or Create an account to join the conversation.
- 11echo
- Offline
- Platinum Member
Less More
- Posts: 351
- Thank you received: 5
16 years 7 months ago - 16 years 7 months ago #4211 by 11echo
Replied by 11echo on topic "Creep" is defined as the
"Creep" is defined as the continued plastic flow of a material under constant load(Press/Temp). So should creep continue, in repests to flanged connections, long enough to reduce gasket load below its sealing requirements, leakage, wire drawing, and even blowout will occur.
MSS SP = Manufacturers Standardization Society - Standard Practice
Good Luck! ...Mark
MSS SP = Manufacturers Standardization Society - Standard Practice
Good Luck! ...Mark
Please Log in or Create an account to join the conversation.
- juan1977
- Offline
- Senior Member
Less More
- Posts: 63
- Thank you received: 0
16 years 2 months ago - 16 years 2 months ago #4541 by juan1977
Replied by juan1977 on topic check the site below. /www.globalspec.com/FeaturedProducts/Detail/EGCEnterprises/Flange_Gasket_Design/50399/0
check the site below.
/www.globalspec.com/FeaturedProducts/Detail/EGCEnterprises/Flange_Gasket_Design/50399/0
/www.globalspec.com/FeaturedProducts/Detail/EGCEnterprises/Flange_Gasket_Design/50399/0
Please Log in or Create an account to join the conversation.
Moderators: Jop
Time to create page: 0.184 seconds