pipe conn.

It is possible you have not gotten an answer to your question because you did not furnish any technical data with which to evaluate your problem.

Data such as:
- The design code for the project (i.e.: ASME B31.3, or other?)
- The commodity
- The maximum operating pressure
- The maximum operating temperature
- The wall schedule of the header and branch pipe
- The kind of system is this?
- Why are you trying to tie a water line to an oil line?

I hope it is not too late to help you.

Also if you would go to the "Training" button on this web site you will fine the following. It is an alternate to using a TEE for a branch connection.


Stub-in (Stub-on):

We talked about using Straight Tees and Reducing Tees as a way to make branches from a line. For low pressure (or reasonably low pressure) there is another way to make branches from a line. This method uses only pipe. It is normally used only for low pressure/low temperature applications where the branch is reducing. The ASME B31.3 (and other piping B31 Code sections) recognize two basic versions of the pipe to pipe branch.

One method is where the run pipe has a hole cut the outside diameter of the branch pipe. This opening is then beveled for a "full penetration weld" The branch pipe is saddle cut (with no bevel) to match the I. D. of the run pipe. They are then fitted together and welded.

The second method is where the diameter of the hole in the run pipe is the same I. D. as the I. D. of the branch pipe. This hole does not get a bevel. The end of the branch pipe is saddle cut to fit the run pipe and is then beveled for a full penetration weld.

With the first method, the branch pipe is inserted in the run pipe. With the second method, the branch pipe is set on the run pipe. Both are still commonly referred to as "Stub-ins"
Both of these can come non-reinforced (as described above) or reinforced. The reinforced version is normally only required for higher stress situations. The reinforcement is a "ring" plate cut from some scrape run pipe or the same material as the run pipe. At the center is a hole the same size as the branch pipe. If cut from flat plate it is then shaped to fit around the run pipe. The width of the ring is normally one half the diameter of the branch pipe. The ring is intended to replace the material that was removed when the hole was cut in the run pipe. A small diameter hole (1/4" NPT) is normally drilled (and tapped) in the ring to act as a vent during the welding process and to allow for Hydrotesting of the welds. The ring is then welded to the branch pipe and the run pipe with full penetration welds. The small hole is fitted with a plug after work is completed.