The Pipers home page
  1. Forum
  3. Piping Design
  5. The Piping Lounge
  7. Piping Specifications

Piping Specifications

  • Anton
  • Anton's Avatar Topic Author
  • Offline
  • Administrator
  • Administrator
More
15 years 6 months ago - 15 years 6 months ago #7412 by Anton
Piping Specifications was created by Anton
Piping Specifications
    All pipe is to be made of a long hole, surrounded by metal centered around the hole.

    All pipe is to be hollow throughout the entire length.

    All pipe is to be the very best quality, preferably tubular or pipular.

    All acid-proof pipe is to be made of acid-proof metal.

    The O.D. of all pipe must exceed the I.D., otherwise the hole will be on the outside of the pipe.

    All pipe is to be supplied with nothing in the hole so that water, steam or other stuff can be put inside at a later date.

    All pipe is to be supplied without rust, as this can be more readily put on at the jobsite.

    All pipe is to be cleaned of coverings such as mud, tar, barnacles or any form of manure before installation, otherwise it will make lumps under the coating.

    All pipe more than 500 feet in length must have the words "Long Pipe" clearly painted on each end so that the fitter will know it is long pipe. Pipe more than two miles in length must also have these words painted on the middle of the length, so that the fitter will not have to walk the full length of the pipe to determine if it is long pipe or not.

    All pipe more than six inches in diameter is to have the words "Large Pipe" painted on it, so that the fitter will not use it for small pipe.

    All pipe closers are to be open at one end.

    No fittings are to be put on the pipe unless specified. If you do, straight pipe becomes crooked pipe.
- If you're the smartest person in the room ... you're in the wrong room.

Please Log in or Create an account to join the conversation.

More
13 years 3 months ago - 13 years 3 months ago #6146 by AbhijitN
Replied by AbhijitN on topic Re: Piping Specifications
Ha ha ha ha ......Very funny.....Anton...!

Thanks,
Abhijit

Please Log in or Create an account to join the conversation.

Moderators: Jop
  1. Forum
  3. Piping Design
  5. The Piping Lounge
  7. Piping Specifications
Time to create page: 0.171 seconds