Hello All,

I once again went through all the training material available with this fantastic website. All the articles provide are very good and very knowledgeable.

But I am seeing one improvement area these. In Piping design and Engineering Squad Checking is also an important activity. And there are different type of squad checks e.g. Supplier Data Review (Vendor drawing/calculations of various equipments, supports) Inter-Discipline Drawings (Structural dwgs. Mechanical L&P dwgs. etc.). There is no article provided which providetips regarding this. If his topic can be included it will resolve lots of queries of newbies in piping design.

Thank You
Siddharth Jain

You must have missed the following,

viewtopic.php?f=1&t=2045&hilit=Vendor+Squad+Check

Please review this and see if it answers your question.

JOP,
Thanks for your reply!!

Forum Thread was good to know the procedure followed for SQCKs. But my suggestion was to provide the bullet points for "What to See/Check" at least in particular documents. e.g. What to look for in a Structural SQCK dwg.

Thank You

Sidjain,

Please e-mail me back (jopennock@netscape.net) and we will discuss a plan
for making this happen.

Regards,