PipingDesigners Community

A place for piping designers, engineers and industry professionals to ask questions, share experience, discuss technical topics and connect with other professionals.

Browse the discussions below or start a new topic. Please keep discussions practical, professional and relevant to the piping and engineering community.

course this depends...
 
Notifications
Clear all

course this depends on what schedule is used for which pound class flange. My question now is; if you set a total…

2 Posts
2 Users
0 Reactions
59 Views
(@hvn83)
Eminent Member
Joined: 16 years ago
Posts: 12
Topic starter   [#370]

Hi guys,

I'm trying to find out something. Currently, I'm making a pipe spec, with a corrosion allowance of 1 mm and a(n extra) mechanical allowance of 0,5 mm.
I use B31.3 for the design of the spec.

Usually, the flange rating is lower than pipe rating (even with a mechanical allowance of 0.5mm), hence the flange makes the spec.
However, now with a total allowance of 0.5 + 1 = 1.5 mm., the pipe (or fitting, however one may see it) rates the spec, the flange usually is stronger.
Of course this depends on what schedule is used for which pound class flange.

My question now is; if you set a total allowance of 1.5 mm (this is allowance is called 'c' in B31.3, para 304.1.1), how is the flange then rated?
Are you allowed to keep/use the standard B16.5 rating?
I'm especially/specifically interested in weld neck raised face ASME B16.5 flanges, a typical flange we use.

My feeling is that (but I'm not sure though) that as long as the flange is rated lower than the pipe/fitting, your good, since (in the case of Weld Neck Raised Flanges) the smallest part of the flange, where the wall thickness is the bevel at the weld neck, which is of the same wall thickness as the pipe/fitting ...



   
Quote
(@jop)
Noble Member
Joined: 20 years ago
Posts: 1164
 

1. I think you are mixing apples and oranges. The corrosion allowance is used along with other factors when selecting the proper wall thickness for the pipe and fittings.

2. The flange rating is based on the Design Pressure and Temperature.

3 When you order your flanges, say Class 300 Raised Face, Weld Neck Flange then you just specify the proper Pipe Schedule so the bore of the flange will match the pipe and fittings.



   
ReplyQuote
Share: