• Creator
    Discussion
  • #5964

    marck1783
    Participant

    Dear all,
    What do you think about 3 field welds on suction and discharge on every piece of rotating equipment?
    The 3 field welds are intended to avoided any breaks on rotating equipment nozzle since can give to mechanical subcontractor 3 adjustment in order to erect correctly the line without any additional loads/stress on nozzle pumps.
    But this choice, in your opinion, increase too much the cost or can be a solution to avoid any break on pump nozzle? Since a field weld is more costly than a weld made in the pipe fab shop (factory).

    Your opinion is really appreciated.
    Best regards

Log in to reply.