image
  • Creator
    Discussion
  • April 30, 2008 at 3:49 pm #6379

    wayne lloyd
    Participant

    I hope I am in the right forum. Any way, here goes. I am trying to find info on set back dimensions when welding slip-on flanges to fittings (Ells,Tees, Reducers, etc.). Thanks for any help.
    Wayne

  • Creator
    Discussion

Log in to reply.

Copyright © 2024 pipingdesigners.com | Powered by a piping designer

Privacy Policy

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .