skgarg@Shrivalabha…….the Pipe rack is already designed according to the loading I am dividing it into four parts along with piping ,supports cable trays and all.
so i am not so concerned about calculation and theortical part ;my main concern is practical one.
@ Willis …..thanx a ton boss ur feedback are quite impressive.
few other queries:—
In this module concept i would have to do hydrotest twice once at shop and then at site Does ASME permits that?
Do you really think its equivalent that i make four spools and then weld them at site by maintaining proper slope of arnd 3% in pipe
OR by making a long spool at shop having the slope of 3% then cutting it into four parts and again joining them on site
Regards
SG
” Be not afraid of going slowly; be afraid only of standing still”