- This topic has 0 replies, 1 voice, and was last updated 18 years, 1 month ago by anbarasan.
-
AuthorPosts
-
October 6, 2006 at 3:05 pm #4787anbarasanParticipant
PTC1 – 1999 – General Instructions
PTC2 – 1980 (R1985) – Code on Definitions and Values
PTC4- 1998 – Fired Steam Generators
PTC4.2 – 1969 (R1997) – Coal Pulverizes
PTC4.3 – 1968 (R1991) – Air Heaters
PTC4.4 – 1981 (R1992) – Gas Turbine Heat Recovery Steam Generators
PTC5 – 1949 – Reciprocating Steam Engines
PTC6 – 1996 – Steam Turbines
PTC6A – 2001 – Test Code for Steam Turbines – Appendix to PTC 6
PTC6-REPORT – Guidance for Evaluation of Measurement Uncertainty in Performance Tests of Steam Turbines
PTC6-S – Procedures for Routine Performance Test of Steam Turbines
PTC7.1 – 1962 (R1969) – Displacement Pumps
PTC8.2 – 1990 – Centrifugal Pumps
PTC9 – 1970 (R1997) – Displacement Compressors, Vacuum Pumps and Blowers
PTC10 – 1997- Test Code on Compressors and Exhausters
PTC11 – 1984 (R1995) – Fans
PTC12.1 – 2000 – Closed Feed water Heaters
PTC12.2 – 1998 – Steam Surface Condensers
PTC12.3 – 1997 – Deaerators
PTC12.4 – 1992 (R1997) – Moisture Separator Reheaters
PTC17 – 1973 (R1997) – Reciprocating Internal-Combustion Engines
PTC18 – 1992 – Hydraulic Prime Movers
PTC18.1 – 1978 (R1984) – Pumping Mode of Pump/Turbines
PTC19.1 – 1998 – Measurement Uncertainty
PTC19.2 – 1987(R1998) – Pressure Measurement
PTC19.3 – 1974 (R1998) – Temperature Measurement
PTC19.5 – 1972 – Application, Part II of Fluid Meters: Interim Supplement on Instruments and Apparatus
PTC19.5.1 – 1964 – Weighing Scales
PTC19.7 – 1980 (R1988) – Measurement of Shaft Power
PTC19.8 – 1970 (R1985) – Measurement of Indicated Power
PTC19.10 – 1981 – Flue and Exhaust Gas Analyses
PTC19.11 – 1997 – Steam and Water Sampling, Conditioning, and Analysis in the Power Cycle
PTC19.14 – 1958 – Linear Measurements
PTC19.22 – 1986 (R1998) – Digital Systems Techniques
PTC19.23 – 1980 (R1985) – Guidance Manual for Model Testing
PTC20.1 – 1977 (R1988) – Speed and Load-Governing Systems for Steam Turbine-Generator Units
PTC20.2 – 1965 (R1986) – Over speed Trip Systems for Steam Turbine-Generator Units
PTC20.3 – 1970 (R1986) – Pressure Control Systems Used on Steam Turbine Generator Units
PTC21 – 1991 – Particulate Matter Collection Equipment
PTC22 – 1997 – Performance Test Code on Gas Turbines
PTC23 – 1986 (R1997) – Atmospheric Water Cooling Equipment
PTC24 – 1976 (R1982) – Ejectors
PTC25 – 1994 – Pressure Relief Devices
PTC26 – 1962 – Speed Governing Systems for Internal Combustion Engine Generator Units
PTC28 – 1965 (R1985) – Determining the Properties of Fine Particulate Matter
PTC29 – 1965 (R1985) – Speed-Governing Systems for Hydraulic Turbine-Generator Units
PTC30 – 1991 (R1998) – Air Cooled Heat Exchangers
PTC31 – 1972 (R1991) – Ion Exchange Equipment
PTC32.1 – 1969 (R1992) – Nuclear Steam Supply Systems
PTC33 – 1978 (R1991) – Large Incinerators
PTC33 – 1979 – Large Incinerators Codes and Appendix Package
PTC33A – 1980 – Abbreviated Incinerator Efficiency Test
PTC36 – 1998 – Measurement of Industrial Sound
PTC38 – 1980 (R1985) – Determining the Concentration of Particulate Matter in a Gas Stream
PTC39.1 – 1980 (R1991) – Condensate Removal Devices for Steam Systems
PTC40 – 1991 – Flue Gas Desulfurization Units
PTC42 – 1988 (R1998) – Wind Turbines
PTC46 – 1997 – Overall Plant Performance
PTCPM – 1993 – Performance Monitoring Guidlines for Steam Power Plants -
AuthorPosts
- You must be logged in to reply to this topic.