- This topic has 0 replies, 1 voice, and was last updated 16 years ago by .
Viewing 1 post (of 1 total)
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.
A 10†pipe branch is taken from 12†pipe header .
Service : Cooling water
Pipe MOC : Galv CS A53 FBW/ A53 B/ API 5LB ( Galv is for small bore viz. upto 2†only )
Corrosion Alwc : 0.125â€
T & Pr : -20 F to 366 F @ 150 psig
Piping Specification requires stub – in connection for 12†x 10†.
Caeser II software requires Pad .
PDS software shows RWELD without Pad .
Pl. give the correct procedure & share info regarding pad requirement for Stub – in / out connections .
Thanks
Copyright © 2024 pipingdesigners.com | Powered by a piping designer