- This topic has 0 replies, 1 voice, and was last updated 15 years, 12 months ago by .
Viewing 1 post (of 1 total)
Viewing 1 post (of 1 total)
- You must be logged in to reply to this topic.
Ok, guys I am in a 9 line bind. I have a small issue with a High Pressure steam line. And a hard headed engineer. Due to space limitations in the field, I need to tap a 16″ 600# Blind Flange CS A105, I need to place an 8″ 90 deg Ell directly to the flange. I need some engineering back up that this is possible.
Operating Conditions are:
47Barg @ 390C and 40T/HR
Basically using the blind as a slip on.
Bob
Copyright © 2024 pipingdesigners.com | Powered by a piping designer