- Posts: 1
- Thank you received: 0
DIN Standards
- Cora
- Topic Author
- Offline
- New Member
Less More
17 years 4 months ago - 17 years 4 months ago #8380 by Cora
DIN Standards was created by Cora
Does anyone have a table that shows the equivalent DIN standards for ANSI class flanges and fittings.
I need the equivalent of 150# flanges and 3000# fittings for a job in China. I think 150# is similar to PN20 but I would like to make sure I call it up correctly.
thanks!
Cora
I need the equivalent of 150# flanges and 3000# fittings for a job in China. I think 150# is similar to PN20 but I would like to make sure I call it up correctly.
thanks!
Cora
Please Log in or Create an account to join the conversation.
- 11echo
- Offline
- Platinum Member
Less More
- Posts: 351
- Thank you received: 5
17 years 3 months ago - 17 years 3 months ago #3906 by 11echo
Replied by 11echo on topic I have 150#, 300#, 600#,
I have 150#, 300#, 600#, & 3000# charts in both Metric and ANSI. I can send these to you in a PDF format ...if that works for you? Just give me and email address. ...Mark
Please Log in or Create an account to join the conversation.
- Anton
- Offline
- Administrator
17 years 2 months ago - 17 years 2 months ago #3939 by Anton
- If you're the smartest person in the room ... you're in the wrong room.
Replied by Anton on topic Mark, If you would like to
Mark,
If you would like to share these around a bit, you can mail them to me and I'll post them on the tools area of the site.
If you would like to share these around a bit, you can mail them to me and I'll post them on the tools area of the site.
- If you're the smartest person in the room ... you're in the wrong room.
Please Log in or Create an account to join the conversation.
- scottg
- Offline
- New Member
Less More
- Posts: 1
- Thank you received: 0
13 years 11 months ago - 13 years 11 months ago #5795 by scottg
Replied by scottg on topic Re: DIN Standards
I looked in the Tools section and did not see the posting for the equivalent DIN standards for ANSI class flanges and fittings.
I could use this information. thanks.
I could use this information. thanks.
Please Log in or Create an account to join the conversation.
- Crashtested
- Offline
- Senior Member
13 years 11 months ago - 13 years 11 months ago #5798 by Crashtested
Please do!
Reality is a trigger word and we're quickly losing touch...
Replied by Crashtested on topic Re:
Mark,
If you would like to share these around a bit, you can mail them to me and I'll post them on the tools area of the site.
Please do!
Reality is a trigger word and we're quickly losing touch...
Please Log in or Create an account to join the conversation.
Moderators: Jop
Time to create page: 0.249 seconds