- Posts: 36
- Thank you received: 0
hydraulic Bolt tensioning device
- ashokaa
-
Topic Author - Offline
- Junior Member
-
Less More
16 years 4 months ago - 16 years 4 months ago #7255 by ashokaa
hydraulic Bolt tensioning device was created by ashokaa
Please explain about hydraulic Bolt tensioning device. And need to know when it required, how much space we have to provide around the flanged joint when we using this. Anything needs to consider when we route the piping.
Thanks.
Thanks.
Please Log in or Create an account to join the conversation.
- Jop
-
- Offline
- Moderator
-
Less More
- Posts: 1053
- Thank you received: 14
16 years 4 months ago - 16 years 4 months ago #4411 by Jop
Do it once and Do it Right
Replied by Jop on topic Check thick web site: http://www.geminiindia.com/services_hydr_bolt.htm You will
Check thick web site:
www.geminiindia.com/services_hydr_bolt.htm
You will see a picture of bolt tensioning in use.
You can also contact them at]This email address is being protected from spambots. You need JavaScript enabled to view it.[/url]
Warehouse
B-12, "N Road,
MIDC Taloja- 410 208.
India.
Tel]This email address is being protected from spambots. You need JavaScript enabled to view it.[/url]
www.geminiindia.com/services_hydr_bolt.htm
You will see a picture of bolt tensioning in use.
You can also contact them at]This email address is being protected from spambots. You need JavaScript enabled to view it.[/url]
Warehouse
B-12, "N Road,
MIDC Taloja- 410 208.
India.
Tel]This email address is being protected from spambots. You need JavaScript enabled to view it.[/url]
Do it once and Do it Right
Please Log in or Create an account to join the conversation.
- juan1977
-
- Offline
- Senior Member
-
Less More
- Posts: 63
- Thank you received: 0
16 years 2 months ago - 16 years 2 months ago #4558 by juan1977
Replied by juan1977 on topic We've used Hydra Tight in
We've used Hydra Tight in the past - for our bolt tensioning requirements. Normally we limit its application to critical equipment like reactors and dont normally used it to tightened the piping joint under 24".
Usual tools of the trade for tightening of the pipe bolted joints like flange is the impact wrench - its fast and cost effective. If you must use a bolt tensioner, ensure that the bolt thread above the nut is of sufficient lengt and there is a space between the nuts for the tool to fit/grab.
Usual tools of the trade for tightening of the pipe bolted joints like flange is the impact wrench - its fast and cost effective. If you must use a bolt tensioner, ensure that the bolt thread above the nut is of sufficient lengt and there is a space between the nuts for the tool to fit/grab.
Please Log in or Create an account to join the conversation.
Moderators: Jop
Time to create page: 0.251 seconds
