- Posts: 16
- Thank you received: 0
Flange gaskets
- anil1729
- Topic Author
- Offline
- New Member
Less More
15 years 5 months ago - 15 years 5 months ago #7437 by anil1729
Flange gaskets was created by anil1729
Hi
Will the gaskets used in class 150 & 300 flanges have the same OD & width?
Will the gaskets used in class 150 & 300 flanges have the same OD & width?
Please Log in or Create an account to join the conversation.
- Anton
- Offline
- Administrator
15 years 5 months ago - 15 years 5 months ago #4854 by Anton
- If you're the smartest person in the room ... you're in the wrong room.
Replied by Anton on topic The gasket ODs will vary,
The gasket ODs will vary, based on a number of factors, including flange rating, and gasket type.
Pipe flange gaskets are used to provide a leak tight seal between two flange faces.
Gaskets are generally available in the following three flange face types:
1) Full Face Gasket - Covers the full face or area of the flange.
2) Flat Ring Gasket - Covers only the sealing area or raised face of the flange.
3) Metallic Ring Gasket - Designed to fit between the U-shaped machined grooves of ring type flanges.
I.D. & O.D. Gasket Diameters:
1) I.D. of full & flat ring gaskets = O.D. of pipe.
2) I.D. of large male & female gaskets = O.D. of pipe.
3) O.D. of full face gaskets = O.D. of flange.
4) O.D. of flat ring gaskets = Diameter of inside edge of flange bolt holes.
5) O.D. of large male & female gaskets = O.D. of male flange face.
I.D. & O.D. of gaskets for other flange faces should equal the flange seals surface.
For further reading, see Training Section - 1 D: Flanges, Gaskets & Bolts
Pipe flange gaskets are used to provide a leak tight seal between two flange faces.
Gaskets are generally available in the following three flange face types:
1) Full Face Gasket - Covers the full face or area of the flange.
2) Flat Ring Gasket - Covers only the sealing area or raised face of the flange.
3) Metallic Ring Gasket - Designed to fit between the U-shaped machined grooves of ring type flanges.
I.D. & O.D. Gasket Diameters:
1) I.D. of full & flat ring gaskets = O.D. of pipe.
2) I.D. of large male & female gaskets = O.D. of pipe.
3) O.D. of full face gaskets = O.D. of flange.
4) O.D. of flat ring gaskets = Diameter of inside edge of flange bolt holes.
5) O.D. of large male & female gaskets = O.D. of male flange face.
I.D. & O.D. of gaskets for other flange faces should equal the flange seals surface.
For further reading, see Training Section - 1 D: Flanges, Gaskets & Bolts
- If you're the smartest person in the room ... you're in the wrong room.
Please Log in or Create an account to join the conversation.
Moderators: Jop
Time to create page: 0.150 seconds