- Posts: 2
- Thank you received: 0
Training
- Moxie
- Topic Author
- Offline
- New Member
Less More
15 years 3 months ago - 15 years 3 months ago #7471 by Moxie
Training was created by Moxie
All,
I need some advise.
I trained to draft pipework / equipment layouts electronically using AutoCad rev13 - 2D: progressed to 3D when AutoCad 2002 became available during 2002; currently modeling using AutoCad 2006, prior to this I was on the tools. I want to move on, to pastures new.
I have looked at what AVEVA and Bentley can offer.
1) Relevant to oportunities: which software package to go for? If any considering:
Since 1982 90% of the installations I have dealt with have been thermoplastic, both thermo-set and thermo-extruded. I am sixty years old and the current job climate is not good.
I need some advise.
I trained to draft pipework / equipment layouts electronically using AutoCad rev13 - 2D: progressed to 3D when AutoCad 2002 became available during 2002; currently modeling using AutoCad 2006, prior to this I was on the tools. I want to move on, to pastures new.
I have looked at what AVEVA and Bentley can offer.
1) Relevant to oportunities: which software package to go for? If any considering:
Since 1982 90% of the installations I have dealt with have been thermoplastic, both thermo-set and thermo-extruded. I am sixty years old and the current job climate is not good.
Please Log in or Create an account to join the conversation.
Moderators: Jop
Time to create page: 0.263 seconds