- Posts: 28
- Thank you received: 0
how to decide nozzle location in a equipment
- KARTHIK
- Topic Author
- Offline
- Junior Member
Less More
14 years 11 months ago - 14 years 11 months ago #7544 by KARTHIK
how to decide nozzle location in a equipment was created by KARTHIK
HI I HAVE A EQUIPMENT I WANT TO FIX THE NOZZLE ON WHT BASIS DO I FIX THE NOZZLE
AND IF THUMB RULE TO BE FOLLOWED WHILE NOZZLE ORINTATION OR LOCATING NOZZLE
AND ON WHT BASIS SHOULS WE KEEP THE DISTANCE B/W 2 NOZZLE PLEASE HELP
AND IF THUMB RULE TO BE FOLLOWED WHILE NOZZLE ORINTATION OR LOCATING NOZZLE
AND ON WHT BASIS SHOULS WE KEEP THE DISTANCE B/W 2 NOZZLE PLEASE HELP
Please Log in or Create an account to join the conversation.
- Anton
- Offline
- Administrator
14 years 11 months ago - 14 years 11 months ago #5114 by Anton
- If you're the smartest person in the room ... you're in the wrong room.
Replied by Anton on topic Re: how to decide nozzle location in a equipment
Karthik,
Take a look at the training section (on the tab above)
In particular, you will see the following section:
Section II - c.1 - Introduction to Vessels and Vessel Orientation
This gives a good overview of vessel and nozzle orientation.
Once you have read this, come back with any questions you may have to build on this.
Anton
Take a look at the training section (on the tab above)
In particular, you will see the following section:
Section II - c.1 - Introduction to Vessels and Vessel Orientation
This gives a good overview of vessel and nozzle orientation.
Once you have read this, come back with any questions you may have to build on this.
Anton
- If you're the smartest person in the room ... you're in the wrong room.
Please Log in or Create an account to join the conversation.
Moderators: Jop
Time to create page: 0.149 seconds