PipingDesigners Community

A place for piping designers, engineers and industry professionals to ask questions, share experience, discuss technical topics and connect with other professionals.

Browse the discussions below or start a new topic. Please keep discussions practical, professional and relevant to the piping and engineering community.

Forums
Community
Valves
 
Notifications
Clear all

Valves

Technical discussions covering valve selection, specification, operation and practical issues.

RSS
Page 2 / 13

piping size

Last post by jagadeesh reddy, 12 years ago

Posts: 3
Views: 46


Who is Beauregard Gustafson?

Last post by Anton Dooley, 12 years ago

Posts: 3
Views: 42


Normally, when putting a spec break in a piping system, we do it at the flange. My question is what about if the…

Last post by hc, 12 years ago

Posts: 8
Views: 72


am being asked (by my boss) to put a S-O-L onto an ecc reducer on the flat side. I personally have never done this.…

Last post by Anton Dooley, 12 years ago

Posts: 11
Views: 94


All, Let us list out the package of documents we (piping) should get to start detail design for the project

Last post by Abhijit N, 12 years ago

Posts: 11
Views: 95


t (sw &thrd) and a plug. The plug was threaded on one end for use during Hydro, and then could be flipped over and…

Last post by Christian Center, 12 years ago

Posts: 7
Views: 76


everyone.. I have worked on many projects and in every other project process or client seems to have different…

Last post by Mark Layport, 13 years ago

Posts: 5
Views: 63


When designing control valve station piping, where is the optimum location for a bypass valve?

Last post by Mark Pearson, 13 years ago

Posts: 5
Views: 23


all, goodmoring, I have a question on flange connection. After deluge valve 8" supplied by vendor with Flat Face…

Last post by James Pennock, 13 years ago

Posts: 3
Views: 58


Hey Guys, I was checking a set of drawings a bit ago

Last post by Mark Layport, 13 years ago

Posts: 7
Views: 67


Page 2 / 13
Share: