PipingDesigners Community
A place for piping designers, engineers and industry professionals to ask questions, share experience, discuss technical topics and connect with other professionals.
Browse the discussions below or start a new topic. Please keep discussions practical, professional and relevant to the piping and engineering community.
It’s been a long time, but as promised I have feedback for you on the success of the shop fabrication of 1½†and below SW piping. The gene...
It’s been a long time, but as promised I have feedback for you on the success of the shop fabrication of 1½†and below SW piping. The gene...
I found these articles on the internet that may help answer your question.
I found these articles on the internet that may help answer your question.
It's so that the flow is as near as is possible to an equal distribution to each unit.
Thank you cj.abhijit and Jop. This confirms for me what I was thinking. It's been many years since I worked on a project with a site plan, and I wasn'...
H Jop, I believe that some construction work packages have been issued with the small bore as shop fabricated, but I'm not sure how it's working out. ...
Thanks 11echo, I totally understand now. I haven't seen these Gruvloks used for tie-ins, but it all makes sense, including the definitions of cold and...
Hi hc, Listen to the advice of experience given here; you're right on the money. I was taught that support placement was part of my job. As Jop points...
[quote]FYI …I see a fair amount of "cold" connections being use these days, usually on low temp critical commodities ...fuel gas, vapor recovery head...
I'm not sure what you mean by a test vent. If you're referring to hydro-test vents and drains, then the answer is yes.