PipingDesigners Community
A place for piping designers, engineers and industry professionals to ask questions, share experience, discuss technical topics and connect with other professionals.
Browse the discussions below or start a new topic. Please keep discussions practical, professional and relevant to the piping and engineering community.
Justin.Walker89, (and any one else who is interested in the same goal) Look in the upper right area of this website at "Contents", Open this section...
My thoughts start with two specific issues: "Definitions" - You said you want to be a "Pipe Designer", but what is your definition of a Pipe Designe...
Ray, The 4" and 1' dimensions you stated above were used widely at the early layout stage back in the day. However, in the end we always deferred to...
Generally speaking that it correct. However, it is recommended that a Soil Analysis be performed to se if it is really required. Have you had a So...
Crashtested, I am sorry you are burdened with the "young man" who maybe needs his diaper changed. :unsure: My recommendation is as follows: 1st....
Okay you are adding a Pipe Guide, but you do not say where you are adding it. On the body of the vessel or on the non pressure Support (Skirt or Legs...
None that I know of, sorry.
Have you checked the "Piping Terms and Definitions" list found on this web site? Go here:
aj63, You made quite a point (.........unless of course you with a certain design outfit in India who went against every industry convention that you...
The following is Shams1's answer. Sorry for adding my request in the wrong location, please find below reply for your queries: 1- Noted, the request...
- Where is your Office and where is this Project? - Do you plan to manufacture/Fabricate your own "Jacketed Pipe" Point #4 - Go here for inform...