PipingDesigners Community

A place for piping designers, engineers and industry professionals to ask questions, share experience, discuss technical topics and connect with other professionals.

Browse the discussions below or start a new topic. Please keep discussions practical, professional and relevant to the piping and engineering community.

Mick McCafferty
@mmc
Active Member
Joined: Feb 12, 2013
Topics: 1 / Replies: 11
Reply
RE: Welding Galvanized Pipe

I find it strange that 3" and above is not galvanized as my understanding that galvanization is for cleanliness in IA Service. Typically 2" and below ...

10 years ago
Forum
Reply
RE: Access for Instrument Items

A common take on this is dependent on the location of orifice flanges etc e.g. I have seen standards stating that no permanent access required up to 4...

10 years ago
Reply
RE: What flange is this

I thought slip-on but weld does not seem to cover enough of the collar so on second thoughts angle of photo maybe only makes it look like flange is we...

10 years ago
Forum
Reply
RE: Removable spools for Air-cooler Inlet piping

Thanks JoP. On reflection I would say that the article does not specifically address removable spools and the examples of inlet and outlet piping may...

10 years ago
Reply
RE: Removable spools for Air-cooler Inlet piping

Arakeri, Try this link for info on coolers and layout.

10 years ago
Reply
RE: Firefighting - Deluge system installation

Further to JOP's advice unless particular piece of equipment mandates that deluge system is required I would expect deluge to be used where monitor co...

11 years ago
Reply
RE: Piping orthos

I would agree that fully detailed Orthos are a waste of manhours these days when piping is detailed in 3D Model and isometrics extracted. Orthos such ...

11 years ago
Reply
RE: Control Valve Assemblies

Garzabla1, I think we are both on same page and to be fair to the younger generation I would think the guys on the boards had the same thoughts about...

11 years ago
Forum
Reply
RE: Control Valve Assemblies

Garzabla1, I would also agree that it is normally top works of CV removed for maintenance but general philosophy we use is to treat all valves whet...

11 years ago
Forum
Reply
RE: Control Valve Assemblies

Hi Anton, Thanks for the prompt reply. My gut feeling is that designers are being discouraged to offset these bypass for a purely cost cutting ...

11 years ago
Forum
Topic
Forum
Replies: 6
Views: 121