Flow transmitter (Flow Element) and Restriction Orifice are essentially thin plates installed. 1. If there's FE installed with instrumentation signal...

Hi, There was an old thread which probably had similar discussion. Regards,

And people like JOP are true artistes. Beautiful to say the least. And may I suggest that these should be added to make an anthology of such thoughts ...

Fluid flow properties (viscosity, density etc.) are related to temperature. The fluid must be in flowing state inside pipe. It will cause problems if ...

SG, Vesseltrim, in general, shall point to the piping and instrument items that will be connected directly to the equipment, but are not fabricated t...

Looks to me as if the wording had to be a little different: Upstream, the line would be anchored. (Fixed) Downstream, there will be rest support (a tr...

In pipe rack large bore lines will be located as close to column (stanchion) as possible i.e. larger the bore, closer it will be to stanchion. The re...

We had used Weld Inch Dia as unit i. e. Circumferential Weld distance converted to straight welding distance. The isometric designed in the design of...

SG, We can also look at it from following point of view: Total Cost Incurred = Installation Cost + Operational Cost When you were looking at it you ...

You are correct, if I had to bet. There are two ways to define it: 1. Gauge Pressure: This is the differential Pressure indicated by the gauge above ...

They are synonymous. And on second thought, add one more synonym BoM : Bill of material Regards,

Dear Sravan, Small questions have a lot of wisdom hidden in them. This link will help you with Control Valves. Regards,