PipingDesigners Community
A place for piping designers, engineers and industry professionals to ask questions, share experience, discuss technical topics and connect with other professionals.
Browse the discussions below or start a new topic. Please keep discussions practical, professional and relevant to the piping and engineering community.
Thanks Jop, It will be a flare stack, I have the stack placed 50m away from other equipment. So I can place the stack basically anywhere, but I guess...
Does "Inserted Pipe" come closer than calling it 'standpipe' as standpipe already has generally accepted definition?
What I did first was to check if this is becoming a trend or had there been some more cases of the same nature. This discussion looks at some of the ...
Here's some more comment on the Dimensioning: [quote]Hi 11echo, I agree with your response. For whatever reason, I was overlooking the fact that the ...
Some part of this discussion is of relevance to this thread: viewtopic.php?f=1&t=2529 From above posts by Anton, Jop & 11echo following two p...
The last time I did "Slurry" piping we used "Pinch Valves" (
Doesn't PUP mean Pipe Up Piece? I had seen this term being used in Ball valves (non flanged) with soft trim. Not sure about site parlance though.
This youtube clip may be of some use:
The only advantage that I see is its quick ON / OFF action and so the decision could be an outcome of HAZOP study. But there could be more, what does ...
Thanks for the replies guys. Its been a while since I visited the forum. The project (detailing scope) was over and since then I have been working on...
Thank you for information. Can you help me with any of the questions I have asked?