PipingDesigners Community

A place for piping designers, engineers and industry professionals to ask questions, share experience, discuss technical topics and connect with other professionals.

Browse the discussions below or start a new topic. Please keep discussions practical, professional and relevant to the piping and engineering community.

What is the technic...
 
Notifications
Clear all

What is the technical term for a pump suction pipe that enters the bottom of a tank and protrudes a foot or so…

6 Posts
6 Users
0 Reactions
100 Views
(@rickcarter)
New Member
Joined: 14 years ago
Posts: 1
Topic starter   [#470]

What is the technical term for a pump suction pipe that enters the bottom of a tank and protrudes a foot or so inside to prevent pulling from the bottom of the tank?



   
Quote
(@jop)
Noble Member
Joined: 20 years ago
Posts: 1164
 

I have three (different) Technical Dictionary's. I checked all three of them plus Webster's. I could not find a definition in any of them that came close to what you have.

I do however, remember working on a horizontal vessel where the pump suction nozzles (out of the bottom of the vessel) had an extension up into the liquid with a Vortex Breaker on top of the projection. The the purpose of this extension was to prevent impurities from being sucked into the pump while supporting the vortex breaker.

I do not remember what we called it. I will do some more research and see if I find anything.

I found this:
http://www.oilngasseparator.info/oil-ha ... types.html

Look at the three examples on the bottom row - left side. They all appear to have an extension of the nozzle up into the tank/Vessel along with a "Cross Plate" Vortex Breaker on top. This is what I remember but here again, no name.

p. s.: this type of question would get more comments and responses if it were in the :"The Technical Forum"



   
ReplyQuote
(@anton)
Member Moderator
Joined: 20 years ago
Posts: 674
 

** Moved from "Piping Lounge" to "The Technical Forum" **



   
ReplyQuote
(@flowr8)
Eminent Member
Joined: 17 years ago
Posts: 41
 

I don't think it has a specific name. I've always referred to this as an internal projection.



   
ReplyQuote
(@shrivallabha)
Estimable Member
Joined: 17 years ago
Posts: 134
 

Does "Inserted Pipe" come closer than calling it 'standpipe' as standpipe already has generally accepted definition?



   
ReplyQuote
(@11echo)
Reputable Member
Joined: 20 years ago
Posts: 332
 

We do this type of thing all the time, however we don't have a "name" for a particular function or shape, we just call them "tank internals" ...and it's deal with on the tank appurtenance drawing and hinted at on the P&IDs.



   
ReplyQuote
Share: