PipingDesigners Community
A place for piping designers, engineers and industry professionals to ask questions, share experience, discuss technical topics and connect with other professionals.
Browse the discussions below or start a new topic. Please keep discussions practical, professional and relevant to the piping and engineering community.
Hi Pipers
What is the maximum thickness variation between two pipes allowed for butt weld ( without any special preparation)?
ASME31.1 states that if the variation exceeds 2mm we give the chamfer (taper bore) the inside diameter of thicker pipe for alignment .
I have also heard a term called transition piece to join the two pipes of different thickness .
what to use when ?
Regards
SG
I have never heard of using a "transition piece" for this purpose. I have used "taper boring" to make the thicker wall match a thinner wall for a proper butt weld.
The extra "transition piece" would be slightly more costly compared to just a simple taper bore of the one thicker item.
- There would be the cost of the extra material
- There would be the cost of the extra (thicker) weld
- There would be the extra space required for the "transition piece"
The term I've heard/used was "back tapering" ...and to do it correctly you need a 4 to 1 taper (min.) for flow purposes ...45 or 30 chamfer won't cut it!
