PipingDesigners Community

A place for piping designers, engineers and industry professionals to ask questions, share experience, discuss technical topics and connect with other professionals.

Browse the discussions below or start a new topic. Please keep discussions practical, professional and relevant to the piping and engineering community.

Is there an Standar...
 
Notifications
Clear all

Is there an Standard where you can find the weights of the different pipe fittings (ASME B16.1, B16.5, B16.9,…

4 Posts
4 Users
0 Reactions
74 Views
(@juanvega)
Eminent Member
Joined: 17 years ago
Posts: 8
Topic starter   [#299]

Hello
Is there an Standard where you can find the weights of the different pipe fittings (ASME B16.1, B16.5, B16.9, B16.11, etc) ? Because inside this ones there isn't. If there isn't a Standard how can I get the weights? Thank you for the help.



   
Quote
(@jop)
Noble Member
Joined: 21 years ago
Posts: 1164
 

Not all piping components of a given type (elbows) but made by different manufacturers will all weight the same. Some piping component manufacturers do not even list the weights of their products so it is hard to find actual weights. It is also near impossible to know at the initial design phase of a project who you are going to buy your material from.

The best you can do is use the average weights for most common items developed many years ago (before my time).

I recommend that you (all) accept and use the tools that are available on this web site:
- go to "Tools"
- then to the second category "Calculators"
- then to the third (Metric) or forth (Imperial) item depending on the units of measure you are using.



   
ReplyQuote
(@cadams50)
New Member
Joined: 17 years ago
Posts: 3
 

Actually that is not completely true. Fittings and components made from materials complying to a specific material standard and to a specific fitting/component standard will all have weights which fall within the allowable range of the standards. The reason a standard does not provide a specific weight for a fitting is two fold -
1. The fitting/component standard can rely on the material standards to provide the tolerance for the production of the pipiing material, while it concentrates on the physical characteristics and their tolerances. This means the standard can be used throughout a range of materials (i.e. low carbon steels)
2. The standard can control the range of the fitting/component weight through the tolerances on the part. Using the average dimensional size for a part to determine the volume and multipling by the average weight per volume unit of the material will get you the average weight of a fitting/component made to that material and fitting/component standard - which is where those tables you are talking about came from.

The manufacturer's production weights vary from this average within the limits of the standard. Their QA/QC program will provide a different (or possibly the same) average production weight value based on how close their production methods are maintained. The closer they hold the values to the midpoint of the standard, the closer they approximate the average weight.

Throughout the process, when they exceed the high or low tolerance values, they are out of standard and the fitting/component no longer meets the specified standards.

So although we are both pointing to using the tables of average values, our answers differ on why.



   
ReplyQuote
(@anton)
Member Moderator
Joined: 21 years ago
Posts: 674
 

Take a look at this pipe hanger guide.
From about page 38 onwards, you will fine some fitting weights.

http://www.anvilintl.com/SharedContent/ ... atalog.pdf



   
ReplyQuote
Share: