PipingDesigners Community
A place for piping designers, engineers and industry professionals to ask questions, share experience, discuss technical topics and connect with other professionals.
Browse the discussions below or start a new topic. Please keep discussions practical, professional and relevant to the piping and engineering community.
Just curious, I referred Roger Hunt. It refers to three distinct phases of plot plan. 1. Proposal Stage : Developed during estimate phase of the plan...
JOP, I agree to your definition and I hope that I've not caused any confusion. My Definition: 2D Loop : Flat Loop (Co - planar geometry) 3D Loop : Cha...
In the limited span that I have had with piping, I did not see Expansion Joints being used (at least) in this case. They were mostly used at large tan...
In the last international project, we had GRE (Glass Reinforced Epoxy) pipes. I think it is similar case. These were used in specifically in water sys...
Anton has suggested that you should start a new thread using the button at top left for a new question. As to your question: Both can be (are) correc...
I will add one more case: If you have to take out a Horizontal Tapping out of the header then you can use: EQUAL TEE + ECCENTRIC REDUCER (Flat Side Do...
I suppose that will be a serious implication from hazard point of view. So I Googled it up:- Following is better thread with some more links. I recomm...
I was little confused until I read the last part of the post. Yes, you are right. As per ASME B31.3, You'll need to check if Minimum thickness of p...
And some more points have come to light after talking to one experienced material engineer. In ASME B 31.3 (Process Piping), the allowable values are...